Forum Thread: Problem with Kali liveUSB (TPlink722n Won't Put on Monitoring Mode.

Problem with Kali liveUSB (TPlink722n Won't Put on Monitoring Mode.

This is what i am doing
root@kali:~# iwconfig
wlan0 IEEE 802.11bgn ESSID:off/any
Mode:Managed Access Point: Not-Associated Tx-Power=20 dBm
Retry short limit:7 RTS thr:off Fragment thr:off
Encryption key:off
Power Management:off

lo no wireless extensions.

eth0 no wireless extensions.

root@kali:~# airmon-ng start insterface
Found 5 processes that could cause trouble.
If airodump-ng, aireplay-ng or airtun-ng stops working after
a short period of time, you may want to kill (some of) them!

PID Name
1132 NetworkManager
1288 wpa_supplicant
1336 dhclient
1645 avahi-daemon
1646 avahi-daemon

PHY Interface Driver Chipset

phy0 wlan0 ath9k_htc Atheros Communications, Inc. AR9271 802.11n

root@kali:~# airodump-ng wlan0
ioctl(SIOCSIWMODE) failed: Device or resource busy

ARP linktype is set to 1 (Ethernet) - expected ARPHRD_IEEE80211,
ARPHRDIEEE80211FULL or ARPHRDIEEE80211PRISM instead. Make
sure RFMON is enabled: run 'airmon-ng start wlan0 <#>'
Sysfs injection support was not found either.

root@kali:~#

please advice. where i am mistaken. thank you

Be the First to Respond

Share Your Thoughts